See Section 10 for part numbers.įigure 1  Cable Kit – Shown in Figure 2 are the normally required cables and connectors. The Perforating Command and Control Panel is available as a portable panel, rack mount panel or integrated into a shooting power supply as a combination rack mount panel. This control panel interfaces with a PC or Laptop via a “USB connector”, connects to a Shooting Power Supply through the “Shooting PWR In” connector and to a wireline cable via the “Wire Line Output” connector.  ControlFire® Perforating Command and Control Panel – Shown in Figure 1 is a surface control panel that provides communication and control to the downhole ControlFire® switch string. Item Equipment Description Titan P/N 1 ControlFire® Command & Control Panel 9002-013-510 2 Cable Kit 9002-013-017 1 3 Wireline Switch Simulator Panel 9002-013-610 4 ControlFire® Perforating Switch Rev 1.8 PCB 1.0D 9002-013-120-1.8 1 5 Wireline Switch Simulator Panel External Test Block 9002-013-320 1 Items 3 and 5 can be used for system verification at the shop or on a job location The minimum equipment required for running a ControlFire® switch system is listed. If equipment is not used in a manner specified by the manufacturer, safety protection may become impairedĬaution: Risk of danger, refer to user guide. When replacing either the AC fuse or W/L fuse always use the exact replacement P/N. When installing into a wireline truck always position the ControlFire® Perf Unit so that the AC cord can be accessible for rapid disconnect. Always use the recommended AC power cord that includes a 3rd wire safety ground that connects equipment to a grounded single phase outlet.

If any service or repair is required the unit must be returned to the manufacturer, Hunting Titan. Do NOT open the unit and try and service. Safety Precautions When Using ControlFire® Perf Unit The following precautions must be followed when using the ControlFire® Perf Unit.

44Ĭopyright©2012 Hunting Titan Doc Number: 10002 37Īrming Instructions for the RF-Safe ControlFire® Assembly. 37Īrming Instructions (Non RF-Safe ControlFire® System). 26 5.4.1 Gun Skip using Switch Skip button in Gun Control Window.

22 5.3.2 Arm and Fire Sequence.23 5.4 Gun Skipping Operations. 15 5.2.1 Create New Job Folder.15 5.2.2 Change W/L Settings.16 5.2.3 Create a New Gun String. 13 5.2 Setup for ControlFire® Operations. Installing ControlFire® Perforating Panel on Logging Truck.12ĬontrolFire® Operation.13ĥ.1 Starting the ControlFire® Software. Installing Software for ControlFire® Perforating Panel. All Rights Reserved.Įquipment Overview.4ĬontrolFire® Perforating Panel and Switch Specifications.

Verifiretools 9.1 download